Electrical power UNITS FOR LIFT TABLE one
Standard Description
This electrical power unit is designed solely to the smaller lift table,Consisting of higher stress gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit has become broadly applied within the sector of logistic gadgets such as minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is controlled through the solenoid valve together with the speed controlled through the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
Common Description
This power unit is created exclusively for that medium lift table, Consisting of hugely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve and also the velocity managed through the adjustable needle valve. When the lift rises to a high positoin, however the power supply is reduce, the lowering movement is managed by the guide override function.
Energy UNITS FOR LIFT TABLE three
Standard Description
This 
energy unit is created exclusively for your massive lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve and also the speed controlled by a strain compensated movement control valve.
Energy UNITS FOR LIFT TABLE four
Standard Description
This power unit is developed exclusively for the massive lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve and the pace controlled by the adjustable needle valve. When the lift rises to a higher positoin, but the power supply is minimize, the decreasing movement is controlled through the manual override perform.
Unique Notes
one. This power unit is of S3 duty cycle, which might only work intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean each of the hydraulic components concerned ahead of installation of the energy unit.
three. Viscosity on the oil shoud be 15~46 cst,which really should also be clean and free of impurities.N46 hydraulic oil is advised.
four. Oil modifying is needed following the initial a hundred operation hrs,afterwards as soon as each and every 3000 hrs.
five. The electrical power unit shown is made to be mounted vertically.
