Material Managing Energy UNIT one
Basic Description
This energy unit is intended for the fork lift market, consisting of very efficient gear pump, DC motor, manual raise and reduced valve, tank, ect. The up and down motion are managed from the lever of the manual release valve, which is outfitted with an electrical switch to activate the motor. The lowing pace is managed from the stress compensated movement management valve.
Particular Notes
one. The duty of this power unit is S3, i.e. 30 seconds on and 270 senconds off.
two. Clean the many hydraulic components concerned ahead of installation of the electrical power unit.
3. Viscosity in the hydraulic oil shoud be 15~46 cst, which should really also be clean and cost-free of impurities, N46 hydraulic oil is encouraged .
four. Oil transforming is needed after the original a hundred operation hours, afterwards once each 3000 hrs.
five. The electrical power unit shown is designed to be mounted horizontally.
Material Handling Electrical power UNIT 2
Common Description
This electrical power unit features energy up gravity down circuit. Activate the start out solenoid to begin the motor to lift the machine. The lowing motion is activated through the solenoid valve with the reducing pace managed by the strain compensated flow management valve. Products of this series might be broadly utilized in the sector of logistic devices including fork lift, mini lift table, and so on.
Particular Notes
1. The duty of this power unit is S3,i.e.,30 seconds on and 270 senconds off.
2. Clean 
every one of the hydraulic elements concerned in advance of mounting the power unit.
3. Viscosity in the hydraulic oil shoud be 15~46 cst,which ought to also be clean and absolutely free of impurities, N46 hydraulic oil is recommended .
four. Oil modifying is required following the first 100 operation hours,afterwards when every single 3000 hours.
5. The power unit need to be mounted horizontally.