SMR Gearbox Installation
Satisfactory performance will depend on correct installation. lubrication and maintenance. for that reason it is vital that the directions during the set up and servicing leaflet. provided with every gearbox. are followed very carefully. several of the significant facets of belt and torque-arm installation are listed below.
one. Install pulley on gearbox input shaft as shut for the reducer probable, and mount reducer on driven shaft as shut to bearing as practical. failure to carry out this can bring about extra loads from the input shaft bearings and output bearings and could bring about their premature failure.
2. Install motor and wedge belt drive using the belt pull at around 90° to the center line in between driven and input shafts. this may allow tensioning with the wedge belt drive with all the torque arm which need to preferably be in tension. if output hub runs anti-clockwise. torque arm ought to be positioned the ideal.
three. lnstall torque-arm fulcrum on the rigid support in order 
that the torque-arm is going to be at somewhere around ideal angles for the center line with the driven shaft and also the torque arm case bolt. ensure that there may be sufficient get up in the turnbuckle for belt stress adjustment.
Maintain near.
Bell drive may be positioned in any easy postion. in case the torque arm should be to be utilised to tighten the belts, the drive should be at about tight angle on the line concerning the input and output shafts.
Bell drive may be located towards the appropriate if sought after.
If output hub rotates clock-wise. place belt drive and torque arm in opposite direction to that shown while in the illustration.
Torque arm and belt consider up.
Torque arm may be mounted to the suitable if sought after.
